Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Darren

Pages: [1]
1
ezPower / Voids not being deducted in Z out
« on: May 18, 2016, 01:07:12 AM »
G'day. I'm using eZPos 13 and have noticed that when a sale is voided, it is not deducted from the Z-out or the Daily Summary. Some other reports are not accurate. Is there a fix for these?

Thanks

2
ezPower / Monthly report by day
« on: November 09, 2011, 11:26:29 PM »
Good day,

Is it possible to get a sales report for a month, broken down into daily sales?

Thanks

3
ezPower / Printer Receipt too long
« on: March 24, 2011, 12:30:14 AM »
Good day again Ronald,

Yet another problem if you could assist, this time with printing a receipt. I have set the setting to have no line feeds, however my recepits are printing out very long. I am currently using the same printer for kitchen and receit, but is feeding about  25cm of roll through after printing each one. Any ideas?

Thanks,

Darren

4
ezPower / Printing Modifiers
« on: March 20, 2011, 11:59:46 PM »
Hi Ronald,

I have come across another problem now. I have set up the system to print modifiers. I works fine when I sell certain items. However when I use build from parts, it shows me the modifier options, but does not print them. I have checked the relevant boxes but can not get it to do what I want. When I manage to get it to print, it prints all the parts and modifiers, instead of just the modifier. For example we sell a chicken burger. This is made up of parts bread roll and chicken breast. This asks for a modifier of which sauce you would like with it, and prints perfectly. We have another option where one can buy a chicken burger meal. This is made up of parts, chicken burger, chips, salad and juice. In order for me to get the system to print the sauce, it also has to print all of the parts, bread roll, chicken breast etc which I obviously dont want. Is there a way around this?

Thanks,

Darren

5
ezPower / No Decimal Places in Extend Column
« on: March 07, 2011, 04:37:52 AM »
Hi Ronald,

In Tax & Precision I am able to change decimal places for quantity, but not for extended column, thus all my prices are round up to the mearest $ with no decimal places. How can I change this?

Thanks,

Darren

Pages: [1]