Denver Research
General Category => ezPower => Topic started by: Darren on March 24, 2011, 12:30:14 AM
-
Good day again Ronald,
Yet another problem if you could assist, this time with printing a receipt. I have set the setting to have no line feeds, however my recepits are printing out very long. I am currently using the same printer for kitchen and receit, but is feeding about 25cm of roll through after printing each one. Any ideas?
Thanks,
Darren
-
It sounds like you are using the Generic Text driver. You need to set the Paper Source to Cont. Feed - With Break
Here is the printer link:
http://www.denverresearch.com/forum2/index.php?topic=3.0
-
That has worked well thanks.
-
I am using a Generic Text Driver and my receipt prints too long. I tried setting the paper source to Cont. Feed - With Break but then the receipt prints too short and cuts it off in the middle of the receipt. What else can I do??
-
Add a few line feeds. Open the Settings / Printer Options and up the line feed amount.